Registration Dossier

Administrative data

First-aid measures

Description of first aid measures
General information: In all cases of doubt, or when symptoms persist, seek medical advice immediately.

After inhalation: Supply fresh air; consult doctor in case of complaints.

After skin contact: Immediately wash with water and soap and rinse thoroughly. If skin irritation continues, consult a doctor.

After eye contact: Rinse opened eye for several minutes under running water. If symptoms persist, consult a doctor. Remove contact lenses.

After swallowing: Give plenty of water to drink. Do not induce vomiting.

Indication of any immediate medical attention and special treatment needed: No further relevant information available.

Fire-fighting measures

Suitable extinguishing agents: CO2, powder, water spray, sand or alcohol resistant foam.

For safety reasons unsuitable extinguishing agents: Water spray, Water with full jet

Special hazards arising from the substance or mixture
- Formation of toxic gases is possible during heating or in case of fire.
- Dust explosion hazard.

Advice for firefighters
Protective equipment: Mouth respiratory protective device.

Accidental release measures

Personal precautions, protective equipment and emergency procedures
- Avoid breathing of resin dust.
- Refer to Handling and storage information

Environmental precautions: Do not allow to enter sewers/ surface or ground water.

Methods and material for containment and cleaning up: Sweep up and put it into a container for disposal.

Reference to other sections: No dangerous substances are released.

Refer to information on safe handling.
Refer to information on personal protection equipment.
Refer to disposal information.

Handling and storage

Handling:
Apply proper ventilation, possibly combined with a local exhaust.
Do not eat, smoke or drink during use. Refer to information on personal protection.
Use only explosion proof equipment.
No special measures required.

Conditions for safe storage, including any incompatibilities
Storage: No special measures necessary for storage. Comply with governmental regulations.
Prevent the accumulation of dust.

Specific end use(s): Additive

Transport information

Shippingopen allclose all
SpecialProvisionsopen allclose all
Shippingopen allclose all
Remarksopen allclose all

Marine transport (UN RTDG/IMDG)

Shippingopen allclose all
Remarksopen allclose all
Shippingopen allclose all
Remarksopen allclose all
SpecialProvisionsopen allclose all

Exposure controls / personal protection

Control parameters
Ingredients with limit values that require monitoring at the workplace: Not required.

Additional information: The lists valid during the making of the Material Safety Data Sheet were used as basis.

Exposure controls

Personal protective equipment:
General protective and hygienic measures:
- If high exposures cannot be avoided use adequate additional protection precautions like a dust-mask.
- Wear at least working clothes and proper gloves.
- Work as much as possible in closed systems. If not feasible install proper ventilation possibly combined with local exhaust.
- Try to reach the lowest possible exposure.
- Keep away from food, beverages and tobacco. Wash hands before taking a break or leaving work.
- Put working clothes away separately.
- Launder contaminated clothing before reuse.

Respiratory protection: If high exposures cannot be avoided use adequate additional protection precautions like a dust-mask.

Protection of hands: Protective gloves
Selection of the glove material on consideration of the penetration times, rates of diffusion and the degradation
- For the permanent contact gloves made of the following materials are suitable: Leather gloves, Synthetic rubber gloves
- For the contact of a maximum of 30-120 minutes gloves made of the following materials are suitable: Leather gloves, Synthetic rubber gloves
- As protection from splashes gloves made of the following materials are suitable: Leather gloves, Synthetic rubber gloves

Stability and reactivity

Stability and reactivity
Reactivity: No further relevant information available.

Chemical stability
Stability: Stable under recommended storage and handling conditions.

Possibility of hazardous reactions Risk of dust explosion.

Conditions to avoid: No further relevant information available.

Incompatible materials: No further relevant information available.

Hazardous decomposition products: None known

Disposal considerations

Waste treatment methods

Recommendation: Waste disposal in accordance with local regulations. Controlled incineration is recommended.