Registration Dossier

Administrative data

First-aid measures

Description of first aid measures
Inhalation

Move the exposed person to fresh air at once. Consult a physician for specific advice.
Skin contact
Wash skin thoroughly with soap and water. Contact physician if irritation persists.
Eye contact
Immediately rinse with water. Continue rinsing for at least for 15 minutes, also under the eyelids. Contact an eye specialist.
Ingestion
Do not give anything by mouth to an uncoscious person. IF SWALLOWED: Immediately call a POISON CENTER or doctor/physician.

Most important symptoms and effects, both acute and delayed
General symptoms and effects
No data recorded.

Indication of any immediate medical attention and special treatment needed
Medical treatment
Treatment according to symptoms.

Fire-fighting measures

Extinguishing media
Suitable extinguishing media
Carbon dioxide (CO2), Dry powder, Foam, Water spray.
Improper extinguishing media
No data recorded.

Special hazards arising from the substance or mixture
Fire and explosion hazards
No data recorded.
Hazardous combustion products
In case of fire may cause harmful and toxic gases, as carbon oxides (CO, CO2) and nitrogen oxides (NOX).

Advice for firefighters
Special protective equipment for firefighters
Personal protective equipment for fire protection. Protective suit against fire and heath and occational chemical splashes (EN 469). Fire Helmet (EN 443). Wear self-contained breathing apparatus (EN 137) and protective gloves against fire (EN 659) and protective shoes against fire (EN 15090). In case of chemical accidents it is recommended to use Chemical protective suit (EN 942-2).
Other information
Fire should be extinguished by limiting below the wind. Suitable extinguishing methods are to be selected according to the environmental conditions. Evacuate area and move people to safe areas.

Accidental release measures

Personal precautions, protective equipment and emergency procedures
General measures
Insure adequate ventilation of work areas. Avoid dust formation. Avoid breathing vapours, mist or gas. Use personal protective equipment.

Environmental precautions
Environmental precautionary measures
Should not be release into the soil, water courses or drain.

Methods and material for containment and cleaning up
Clean up
Collect mechanically into suitable containers for disposal. Dispose off as a hazardous waste according to local and national regulations. Avoid breathing vapours. The area should be ventilated and cleaned after collecting the material.

Handling and storage

Precautions for safe handling
Handling
Should be handled according to good hygiene- and security practice. Use personal protective equipment. Avoid contact with skin, eyes and clothing. Use sufficient ventilation. Keep away from sources of ignition.

Conditions for safe storage, including any incompatibilities
Conditions for safe storage
Technical measures and storage conditions
Store in a dry, cool and well-ventilated place

Transport information

Land transport (ADR/RID)

UN number:
1759
Shippingopen allclose all
Class:
8
Packaging group:
II
SpecialProvisionsopen allclose all

Inland waterway transport (ADN(R))

UN number:
1759
Shippingopen allclose all
Class:
8
Packaging group:
II
Remarksopen allclose all

Marine transport (IMDG)

UN number:
1759
Class:
8
Packaging group:
II
Remarksopen allclose all

Air transport ICAO/IATA

UN number:
1759
Class:
8
Packaging group:
II
Remarksopen allclose all
SpecialProvisionsopen allclose all

Exposure controls / personal protection

Precautionary measures to prevent exposure
Technical measures to prevent exposure
If enclosed handling cannot be guaranteed, ventilation and protective clothing must be used. Avoid contact with skin, eyes and clothing. Wash hands and face before beaks and immediately after handling the product. Work rooms should be equipped with an eyewash bottle with clean water and emergency shower. Work clothes should be kept separate; Immediately remove contaminated clothing and wash before reuse properly.

Eye / face protection
Eye protection equipment
Description: Full face-protection. Goggles and full face-shield or Proflow/Autoflow with face mask.
Reference to relevant standard: EN 166.

Hand protection
Hand protection equipment
Description: Use CE- marked chemical protective gloves. There is no specific information for the suitable glove material and break through times for this material. The material is solid, therefore Neoprene-or Butyl rubber gloves or long sleeve PVC- gloves are applicable; For example neoprene; KCL Camapren art. 0722 (0.6 mm) tai butyl; KCL Butoject art. 0897 (0.3 mm), 0898 (0.7 mm) and PVC-gloves: for example North, Famon. Make sure there is no bare skin area between the glove arm and the protective suit sleeve. Contaminated gloves should be removed immediately and replaced for the new ones.
Reference to relevant standard: EN 374, EN 388.
Hand protection, comments
Use proper glove removal techniques to avoid contact with the outside of the glove.

Skin protection
Recommended protective clothing
Description: Use protective clothing according the operation requirements. In case of danger of exposure to the chemical splashes, use at least chemical suit type EN 14605 4/5/6, e.g Tyvek Classic Plus or comparable. Feet protection: shoe covers (Tychem F is applicable) or rubber boots. Reference to relevant standard: EN 14325:2004, CE Category III, EN 14605 type 4. EN 13982-1 type 5. EN 130346 type 6. EN 1149-5.

Respiratory protection
Recommended respiratory protection

Description: ABEK-P3- combined respirator with Autoflow- or Proflow- blower provided with suitable facemask is applicable. The protection capacity sufficiency of the breathing apparatus/equipment ensemble to minimize the exposure has to be assured. With high concentrations wear a positive-pressure supplied fresh air equipment. Reference to relevant standard: EN 14387, EN 12941, EN 12942, EN 136, EN 137, EN 143.
Respiratory protection, comments
The selection of the respiratory protection should be based on risk assessment. The choice must be based on known or anticipated exposure levels, the hazards of the product and the selected respirator safe working limits. Filter device should only be used for 2 hours at the time.

Appropriate environmental exposure control
Environmental exposure controls, comments
Should not be released into the environment.

Exposure controls
Exposure controls, comments
Personal protective equipment selection should be based on risk assessment. Personal protective equipment should be selected according to the concentration and the amount of material to be handled, taking into account exposure risks.

Stability and reactivity

Reactivity
No hazardous reactions when stored and handled according to prescribed instructions.

Chemical stability
Stability
No data recorded.

Possibility of hazardous reactions
Possibility of hazardous reactions
No data recorded.

Conditions to avoid
No data recorded.

Incompatible materials
Materials to avoid
Strong oxidising substances.

Hazardous decomposition products
In case of fire may cause harmful and toxic gases, as carbon oxides (CO, CO2) and nitrogen oxides (NOX).

Disposal considerations

Dispose of as a hazardous waste according to local and national regulations.