Registration Dossier

Administrative data

First-aid measures

Emergency measure - Inhalation: In case of inhalation remove patient to fresh air
immediately. If not breathing give artificial respiration.
If breathing is difficult, give oxygen. Get medical aid. The
material may cause respiratory tract irritation.
Emergency measure - Eyes: In case of eye contact flush eyes with plenty of water for
at least 15 minutes, occasionally lifting the upper and
lower lids. Seek medical aid immediately.
Emergency measure - Skin: In case of skin contact wash affected area with soap and
water. Seek medical advice if skin irritation persists.
Emergency measure - Ingestion: Seek medical attention.

Fire-fighting measures

Recommended extinguishing agent: Use water-spray, dry chemical, Carbon dioxide or foam
extinguisher.

Product arising from burning: The substance is combustible and will burn if involved in a
fire, evolving noxious fumes (eg carbon oxides and halogen
containing compounds). However, there is no experimental
evidence to support the anticipated combustion products.

Product determined by test: N

Protective equipment: Full protective clothing and self-contained breathing
apparatus must be worn.

Accidental release measures

Emergency measures in case of spillage: Evacuate personnel from immediate vicinity.


Wear appropriate personal protective equipment conforming to
the relevant national or international standards as
mentioned in section 2.3.10.


Avoid dust formation by damping down with water. Absorb
spillages of solutions with a suitable inert material (eg
sand or soil). Carefully transfer the spillage to waste
containers, or use a sealed industrial vacuum machine.
Containers filled with waste material must be labelled in
the same way as the original containers.


Clean the spillage area with water and detergent. Do not
direct washings to the drain.


Dispose of waste material by incineration in accordance with
local regulations.

Handling and storage

Handling: The substance should be handled and used in conditions of
good industrial hygiene and in conformity with any local
regulations in order to avoid exposure.


Engineering controls are necessary to reduce exposure to the
substance.


When exposure cannot be prevented or adequately controlled
appropriate personal protective equipment should be worn.
Such protective equipment should conform to the appropriate
international or national standards as follows;

Chemical protective gloves to Standard EN374

Chemical resistant clothing to Standard EN368

Eye protection to Standard EN166


When necessary appropriate respiratory protection should be
used. e.g. a dust mask conforming to EN149 FFP1.


The standards mentioned above should be regarded as a
minimum.

Storage: Store refrigerated preferably.


Keep containers tightly closed when not in use.

Packaging of the substance and or preparation: 1.5 litre high-density polyethylene bottles with
polypropylene caps.

Transport information

Shippingopen allclose all
SpecialProvisionsopen allclose all
Shippingopen allclose all
Remarksopen allclose all

Marine transport (UN RTDG/IMDG)

Shippingopen allclose all
Remarksopen allclose all

Air transport (UN RTDG/ICAO/IATA)

Shippingopen allclose all
Special provisions / remarks
Remarks:
Transport code: None.
Transport: None.
SpecialProvisionsopen allclose all

Exposure controls / personal protection

Stability and reactivity

Danger other than fire: None reported

Chemical reaction with water: None reported

Dust explosion: Not anticipated. The material is manufactured in such a way,
and in small amounts as to preclude any potential dust
explosion hazard.

Dust explosion determined by test: N

Disposal considerations

Industry - Possibility of recovery/recycling: Discharge to the environment will be minimal to none.
Recovery from minor spillages or accidental discharge is not
economically or technically feasible, and such waste
material will be disposed of by incineration. In principle,
it may be possible to recover larger spillages of
uncontaminated material for subsequent use.

Industry - Possibility of neutralisation: The notification tests have shown that the substance is not
considered hazardous to health.


No chemical treatment is practicable to neutralise any
hazardous health properties.


The dust hazard will be minimised by appropriate handling
and storage measures.

Industry - Possibility of destruction: controlled discharge: Contaminated containers or spillages of solutions mixed with
inert material (eg sand or soil) should not be disposed of
by landfill.

Industry - Possibility of destruction - incineration: The substance can be disposed of by incineration by burning
under controlled conditions at a licensed waste treatment
processor designed to handle halogenated waste in accordance
with local regulations. Stack gases should be scrubbed,
because noxious fumes (eg carbon oxides and halogen
containing compounds) could be formed.

Industry - Possibility of destruction - water purification: The substance should not normally be discharged directly to
the sewage system or the aqueous environment. However,
adverse effects on sewage treatment systems are not
envisaged at this supply level.

Industry - Possibility of destruction - other: None.

Public at large - Possibility of recovery/recycling: Not applicable as the substance will not enter the public
domain.

Public at large - Possibility of neutralisation: Not applicable.