Registration Dossier

Diss Factsheets

Administrative data

First-aid measures

4.1 Description of first aid measures
After inhalation: Supply fresh air; consult doctor in case of complaints.
After skin contct: Immediately wash with water and soap and rinse thoroughly. If skin irritation continues, consult a doctor.
After eye contact: Rinse open eye for a several minutes under running water. If symptoms persist, consult a doctor.
After swallowing: Rinse out mouth with water. Never give anything by mouth to an unconscious person. If symptoms persist consult a doctor.

4.2 Most important symtomps and effects, both acute and delayed: No further relevant information avaiblable.

4.3 Indication of any immediate medical attention and special treatment needed: No further relevant infomarion available.

Fire-fighting measures

5.1 Extinguishing media
Suitable extinguishing agents: CO2 powder or water spray. Fight larger fires with water spray or alcohol resisten foam.

5.2 Spezial hazards arising from the substance or mixture: No further relevant information available.

5.3 Advice for firefighters
Protective equipment: Wear fully protective suit. Mouth respiratory protective device.

Accidental release measures

6.1 Personal precautions, protective equipment and emergency procedures
Wear protective equipment. Keep unprotected persons away.
Ensure adequate ventilation.
Avoid formation of dust.
Use respiratory protective device against the effects of fumes/dust/aerosol.
Avoid contact with eyes.
Avoid contact with skin.

6.2 Enviroment precautions: Do not allow to enter sewers/ surface or ground water.

6.3 Methods and material for containment and cleaning up:
Pick up mechanically.
Dispose contaminated materials as waste accordning to item 13.

Handling and storage

7.1 Precautions for safe handling
Thorough dedusting.
Ensure good ventilation/exhaustion at the workplace.
Keep receptacles tightly sealed.
Prevent formation of dust.
Avoid contact with skin and eyes.
Information about fire - and explosion protection: Normal measures for preventive fire protection.

7.2 Conditions for safe storage, including any incompatibilities:
Requirement to be met by storerooms and receptacles:
Store in a cool location.
Store only in the original receptacle.
Information about storage in one common storage facility:
Store away from foodstuff.
Store away from water.
Further information about storage conditions: Store in cool, dry consitions in well sealed receptacles.

7.3 Specific end use(s): No firther relevant information available.

Transport information

Land transport (UN RTDG/ADR/RID)

UN number:
Not applicable
Shippingopen allclose all
SpecialProvisionsopen allclose all

Inland waterway transport (UN RTDG/ADN(R))

UN number:
Not applicable
Shippingopen allclose all
Remarksopen allclose all

Marine transport (UN RTDG/IMDG)

UN number:
Not applicable
Shippingopen allclose all
Remarksopen allclose all

Air transport (UN RTDG/ICAO/IATA)

UN number:
Not applicable
Shippingopen allclose all
Remarksopen allclose all
SpecialProvisionsopen allclose all

Exposure controls / personal protection

8.1 Control parameters
Ingredients with limit values that require monitoring at the workplace:
The product does not contain any relevant quantities of material with critical values that have to be monitored at the workplace.
DNELs: Not applicable.
PNECs: Not applicable.

Additional information: The lists valid during the marking were used as basis.

8.2 Exposure controls
Based on composition , the following messures are suggested for occupational safety measure:
Appropriate engineering controls: See Handling and storage.

Personal protective equipment:
Respiratory protection: Suitable respiratory protective device recommended.
Protection of hands:
The glove material has to be impermeable and resistant tot he product/ the substance/ the preparation.
Due to missing tests no recommendation to the glove material can be given for the product/ the preparation/ the chemical mixture.
Selection of the glove material on consideration of the penetration times, rates of diffusion and the degradation.
Material of gloves:
The selection of the suitable gloves does not only depend on the material, but also on further marks of quality and varies from manufacturer to manufacturer. As the product is a preparation of several substances, the resistance of the glove material can not be calculated in advance and has therefore to be checked prior to the application.
Penetration time of glove material:
The exact break through time has to be found out by the manufacturer of the protective gloves and has to be observed.
Eye protection: Safety glasses
Environmental exposure controls:
Control measures must be made in accordance with Community environmental protection legislation.

Stability and reactivity

10.1 Reactivity: No decomposition if used according to specification.
10.2 Chemical stablility: Stable under recommended storage conditions.
10.3 Possibility of hazardous reactions: No dangerous reactions known.
10.4 Conditions to avoid: No further relevant information available.
10.5 Incompatible materials: No further relevant information available.
10.6 Hazardous decompositin products: No dangerous decomposition products known.

Disposal considerations

13.1 Waste treatment methods
Recommendation: Smaller quantities can be disposed of with household waste.

Uncleaned packaging:
Recommendation: Disposal must be made according to official regulations.

Categories Display