Registration Dossier

Data platform availability banner - registered substances factsheets

Please be aware that this old REACH registration data factsheet is no longer maintained; it remains frozen as of 19th May 2023.

The new ECHA CHEM database has been released by ECHA, and it now contains all REACH registration data. There are more details on the transition of ECHA's published data to ECHA CHEM here.

Diss Factsheets

Administrative data

First-aid measures

General advice :

Take care to self-protect by avoiding becoming contaminated.

Use adequate respiratory protection.

Move contaminated patient(s) out of the dangerous area.

Take off all contaminated clothing and shoes.

Inhalation :

At ambient/normal handling temperatures, minimal or no irritation due to inhalation of vapour/mist is expected. Seek medical attention if breathing is difficult.

Skin contact :

Wash contact areas with soap and water. If irritation occurs, get medical assistance.

Eye contact :

Flush thoroughly with water. If irritation occurs, get medical assistance.

Ingestion :

First aid is normally not required. Seek medical attention if discomfort occurs.

Fire-fighting measures

Suitable extinguishing media :

LARGE FIRE: Use water spray, water fog or foam. DO NOT use direct water jet.

SMALL FIRE: Dry powder or carbon dioxide (CO2) extinguisher, dry sand or fire fighting foam.

Unsuitable Extinguishing Media :

(Do not use) Direct water jet.

Simultaneous use of foam and water on the same surface is to be avoided as water destroys the foam.

Combustion Products :

Carbon monoxide, carbon dioxide and unburned hydrocarbons (smoke).

Specific hazards during fire fighting :

Containers may explode under fire conditions - use water spray to cool unopened containers.

Do not allow run-off from fire fighting to enter drains or water courses – may cause explosion hazard in drains and may reignite on surface water.

Further information :

Special protective equipment for fire-fighters :

Wear an approved positive pressure self-contained breathing apparatus in addition to standard fire fighting gear.

Accidental release measures

Eliminate all ignition sources (no smoking, flares, sparks or flames in immediate area).

Personal precautions :

Wear personal protective equipment.

Avoid breathing vapours or mist.

Ensure adequate ventilation and absence of sources of ignition.

Environmental precautions :

Land spillage :

Prevent further leakage or spillage if safe to do so.

Prevent spillage from entering drains, sewer, basement or confined areas.

Water spillage :

Prevent further leakage or spillage if safe to do so.

If the spillage contaminates rivers, lakes or drains inform respective authorities.

Methods for clean up :

Land spillage:

Contain spillage.

Spillages can be taken up by collection with non-combustible absorbent material, (e.g. sand, earth,

diatomaceous earth, vermiculite) and placed in container for disposal according to local / national

regulations.

Water spillage:

Contain with booms or barriers, use surface acting agents to thicken spilled materials.

Remove trapped material with suction hoses.

Further accidental release measures :

Ensure all equipment is non sparking or electrically bonded.

Avoid direct contact with released material.

Stay upwind.

Keep non-involved personnel away from the area of spillage.

Ensure adequate ventilation, especially in confined areas.

Handling and storage

Advice on safe handling :

Smoking, eating and drinking should be prohibited.

Avoid all sources of ignition.

Avoid contact with heat, ignition sources and oxidizing agents.

Use only in well ventilated areas.

Containers should be opened only under exhaust ventilation hood.

Use proper bonding and/or grounding procedures.

This material is a static accumulator: Take precautionary measures against static discharges.

Do not allow splash filling of bulk volumes.

Do not use compressed air for filling, discharging or handling.

Do not pressurise, cut, weld, braze, solder, drill, or grind on containers.

The vapour is heavier than air, beware of accumulation in pits and confined spaces.

Cleaning, inspection and maintenance of the internal structure of storage tanks must be done

only by properly equipped and qualified personnel as defined by national, local or company regulation.

Dispose of rinse water in accordance with local and national regulations.

Storage :

No smoking.

Store in either mild steel or stainless steel containers or vessels.

Store in a designated cool and well-ventilated place.

Store in the original, tightly closed, container.

Containers which are opened must be carefully resealed and kept upright to prevent leakage.

Keep container tightly closed and properly labelled.

Storage installations should be designed with adequate bunds so as to prevent ground and water pollution in case of leaks or spills.

Fixed storage containers, transfer containers and associated equipment should be earthed and bonded to prevent accumulation of static charge.

Transport information

Shippingopen allclose all
SpecialProvisionsopen allclose all
Shippingopen allclose all
Remarksopen allclose all

Marine transport (UN RTDG/IMDG)

Shippingopen allclose all
Remarksopen allclose all
Shippingopen allclose all
Remarksopen allclose all
SpecialProvisionsopen allclose all

Exposure controls / personal protection

Stability and reactivity

Disposal considerations